Stability problems after 4.4.0 update

[Nick Carthew]

To balance this topic, I too use an iPhone 11 running iOS 18.5 and I have no issues but I am not using CarPlay or a Carpuride, purely phone navigation.

[Westerwald_Rider]

@Jeroen-1s : HI Jeroen, I got the same issue with android 13 and SAMSUNG S20 FE, Carpuride W903.
I got a freeze during the first time with carplay. I restartet my Smartphone, the carpuride and it runs.
It hangs up, when motors stops at signal light and you start the engine. I think it hangs at CARPLAY to transfer the display. Because the smartphone voice will direct you. So far you can hear it. In my case the voice was very quiet. But it works, when you set volume strengt in the MRA app. And don't touch the volume buttons on your steering wheel. If you restart carplay for a short time and resume to navigation it runs. Please bag my pardon, my experience is very young and fresh. I will check these out during my holiday trip.
I tried it first for short navigation targets in Areas I know where I am. So I am able to check out the app. I used it in my car and later with my Bike.

Issues:
Hang up when you start your engine at signal light.
the volume is very low, see other thread.

positive:
I learned a lot of new corners in my home area.

have a good ride

best regards from Westerwald

[Adrian Avram]

@Nick-Carthew this issues are occurring only on CarPlay and AA.
I tried as well with my iPhone 13 and AA on my car and got frozen almost every time I tried to use it. Luckily I managed to downgrade the app on my Android to 4.3.9, and I will use it as is.

[Larry Greenfield]

I’m having exactly the same problem with iPhone 11 and Carpuride 702B so it’s not just you. Position freezes on both the phone and the CarPlay. Resetting the route updates the location but it still doesn’t move.

But does not seem to be 200% reproducible yet.

[Jeroen 1s]

Over the past two days, I embarked on a lengthy tour of nearly 1,000 km. It was a great opportunity to test the Myroute app again thoroughly. Unfortunately, halfway through the first day of the tour, I had to load my GPX files into TomTom Go due to many instability issues with Myroute.

• In the first few hours, the phone became very hot and slow, maps were no longer updated and navigation seemed to stop working.
• After a full reset of the device, it worked fine again for a while. However, after a while, the device started recalculating and got stuck again. The distance travelled was no longer updated and the directions were no longer accurate.

This was the point at which I finally decided to go back to TomTom Go. Myroute App is a brilliant product in terms of functionality because everything is in one ecosystem. However, stability during navigation is obviously the most important thing for me and many other drivers. You can see that TomTom has been fully developed and no longer contains any bugs, which means that, in my opinion, TomTom Go is still the best. When MyRoute is as stable as TomTom, I will be the first to switch back, but I fear that this will take some time. A lifetime subscription is still a bridge too far for me at the moment

[Con Hennekens]

@Jeroen-1s said in Stability problems after 4.4.0 update:

In the first few hours, the phone became very hot and slow, maps were no longer updated and navigation seemed to stop working.

Since big steps have been set concerning the power drain, phones getting so hot they don't function normally anymore are largely a thing of the past. It would be good at such a time to make a screenshot of the battery usage, to be able to see which app is drawing the current. It could as well be a system app or process generating this, while you blame the MRA app. I know it is easy to think the MRA app is the culprit because that is what you are using at that moment, and it is not impossible of course, but it would be good to see proof about that, and a support ticket so they can perhaps do something about it.

[Adrian Avram]

@Con-Hennekens said in Stability problems after 4.4.0 update:

I know it is easy to think the MRA app is the culprit because that is what you are using at that moment

Sorry to say this, but I agree with @Jeroen-1s ... I used TomTom Go last year for a Balkan Tour trip, and worked perfectly without any issues, so please stop pretending that MRA is perfect, meanwhile all these users are complaining about stability issues! I bought the app and planner (GOLD member) and I cannot use it without a downgrade to the previous version ....
I understand that there is no fix for now, even Corjan admitted this, so please stop praising MRA when someone has issues with the app !

[Con Hennekens]

@Adrian-Avram, I am not pretending that MRA is perfect, but if you want to solve anything, you need to look at other possible culprits too. There are many...

[Manzo91]

@Adrian-Avram same situation .. i hope next update resolve all the issues.

[Adrian Avram]

@Con-Hennekens said in Stability problems after 4.4.0 update:

but if you want to solve anything, you need to look at other possible culprits too. There are many...

In my case, its MRA. This has already been decided, and now I am waiting for the next update, maybe it will fix things ...